Audio Control DQL-8 Spezifikationen PDF herunterladen (Seite 30)

Owner’s Enjoyment Manual

AudioControl®

Troubleshooting

No Power: If the blue display on your

DQL-8 will not turn on, check to make sure

that the power wire and remote turn-on wires

are connected properly or a fuse has not blown.

GTO circuit will turn the DQL-8 on automati

-

cally with signal from the OEM system.

System Sounds Unbalanced: Check your

graphic and parametric equalization settings to

make sure that one channel is not dramatically

different than another.

No Output: If one or more of your outputs

seem to have…no output, than you will want to

confirm that the Inputs are connected properly,

and that you have the Input Mode set properly.

E.g., if you are in “2 Channel” mode, then you

will not have sound from your rear outputs.

Also, make sure your master volume level is set

high enough.

Sounds Distorted: Should your system

sound distorted or your speakers are moving way

too much, you should make sure you have your

levels matched properly and that your ampli

-

fier gains are set at minimum. If this checks out

27

okay, you will want to look at your EQ controls

to insure that your boost levels are not overly

boosted.

Still Sounds Distorted: Look at the fre-

quencies that you have selected for FrontPEQ1

and FrontPEQ 2 and see how much boost or cut

you have applied. Then look at those same fre

-

quencies on your Graphic EQ. If you have boost

applied to the same frequencies on both types

of equalizers, there is a strong chance you are

overdriving your speakers and amplifiers at that

frequency.

Output Voltage LEDs Don’t Light Up:

If your system is playing music but none of the

output LED’s are on, there is a good chance that

the output voltage of your source unit is not

that strong. Try reducing the gains on the after

-

market amplifier and running the OEM system

at higher levels.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare