Audio Control DQL-8 Spezifikationen PDF herunterladen (Seite 10)

Owner’s Enjoyment Manual

AudioControl®

A GUIDED TOUR OF DQL-8

❶ Digital Dash Control (DDC) Input:

This input allows you to connect the optional

AudioControl Digital Dash Control (DDC) which

will control your DQL-8 from the convenience

of the driver’s seat, passengers seat, back seat or

anywhere else the cable will stretch. See your

authorized AudioControl dealer for more infor

mation about this option or check out www.

audiocontrol.com.

❷ Auxiliary Input: This input accepts

a two-channel audio signal from a secondary

source unit (i.e., iPod, satellite radio, or turntable)

and feeds it into the front, rear, and subwoofer

output channels, depending upon which of the

Output Modes is selected. The input is activated

when you tap the dash control knob. The Aux

Input is selected when the LED is on.

❸ Speaker Level Inputs: The DQL-8 has

eight speaker-level inputs. These inputs get their

signals from the speaker-level outputs of your

factory-installed source unit or amplifier (if your

vehicle is so equipped). If your source unit has

front, rear, and subwoofer speaker-level outputs,

connect them to the appropriate inputs on your

DQL-8. If the source unit only has front and rear

inputs, the Auto Mode circuitry in your DQL-8

automatically routes the Channel 3 / Rear input

channels to the subwoofer channels.

❹ Input Level: These knobs allow you to

maximize the signal level that goes from your

source unit into your DQL-8 to achieve maxi

mum signal-to-noise ratio.

❺ Input Maximized Indicators: These

nifty LED’s (Light Emitting Diode if you are curi

ous) indicate that you are supplying the DQL-8

digital signal processor its optimum signal volt

age. If the LED indicators never come on, don’t

assume that it is not working (since LED’s rarely

break) but you might consider adding a line driv

er to your system for more input signal strength.

❻ Output Level Controls: Although your

DQL-8 has the ability to increase your signal

voltage, your amplifiers may not necessarily ac

cept that high a signal. These controls allow you

to regulate the proper amount of pre-amp signal

from the DQL-8 to the amplifiers.

❼ Select: Use this button to select one of the

various equalization, crossover, display, or mem

ory modes of your DQL-8.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Audio Control DQL-8 Spezifikationen Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto-Medienempfänger Audio Control DQL-8