Audio Control DQL-8 Spezifikationen Seite 19

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 36
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 18
Owners Enjoyment Manual
The Strength of Digital
16
Level Matching
If you have ever listened to a friend’s “killer”
car audio system and heard lots of hiss then you
have experienced an improperly level-matched
system. When a performance autosound system
is properly level matched, you should get the
maximum output from your source unit and
amplifiers without any clipping or that annoy
-
ing hiss! The following steps will help guide you
through the process, although at the end of the
day, your ears will be your guide!
1) Set your source unit’s fader and balance con
-
trols to their center positions.
2) Disconnect the output RCA connections
between your DQL-8 and the amplifier(s) . . . oth
-
erwise get some earplugs.
3) Start playing some relatively dynamic music
and set the volume on your source unit to about
3/4 of maximum. You should not hear anything
at this point. If you are hearing music, go back
to step #2. If you are hearing voices, go see a doc
-
tor!
4) Starting with the DQL-8 “Input Level” con
-
trols, adjust the control knobs until the “Input
Maximized” LED’s begin to flicker steadily with
the music.
5) Now adjust the output level control until
the “2 volt” or “5 volt” light starts to flicker. You
will want the output voltage to match up to
your amplifier’s input gain levels. If you don’t
know how much this is, ASK the amplifier
manufacturer or read the owner’s manual of the
amplifier.
6) Very Important - Set the input gains on the
amplifier(s) at minimum!
7) Double check that you performed Step #6
8) Decrease the volume control on your source
unit and re-connect the RCAs between the
DQL-8 and the amplifier(s).
9) Now increase the volume on your source
unit to your normal listening level. For some of
you, this may be louder than others!
10) At this point you may find yourself going
back and adjusting the “Output Level” controls
on your DQL-8 to accommodate for the speaker
placement and efficiency.
Seitenansicht 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare