Audio Control EQS Spezifikationen PDF herunterladen (Seite 10)

Owner’s Enjoyment Manual

INSTALLING THE EQS

Up to this point everything you have read has served to

educate you on the operations of EQS. We are sure that you

are chomping at the bit to install EQS so we recommend you

read the following sections very carefully.

A. Placement & Mounting Of EQS

Placement: The EQS needs to be installed in the signal

path after your source unit but definitely before your

amplifiers and or any active crossovers. The chassis is usually

mounted in the rear of the vehicle close to the amplifiers as

possible.

Mounting: Once you have selected a permanent

mounting location, position the unit and mark the appropri-

ate mounting holes with a felt-tip pin or scratch awl. Before

doing anything else, make sure you are not about to drill a

hole in a gas tank or piercing any existing wiring. Nothing

ruins your day more than an expensive repair bill. Drill a few

small pilot holes and secure the chassis of the EQS with self-

tapping screws.

B. EQS Power Wiring

WARNING: Failure to disconnect the negative terminal of

your battery prior to the installation of you EQS can result in a

warm tingly feeling.

Remote Turn-On: Connect a 22 to 18 gauge wire from

the head-unit’s remote turn-on to the “Remote” connector

on the EQS .

Positive(+12V) Connection: Insert a 12-18 gauge

wire into the connector labeled “Power” on the nifty

connector of your EQS. Connect it to a good constant

source of 12 volts (we suggest the battery), fused at 2 amp.

Ground Connection: Use the same gauge wire as you

did for the positive connector and run it from the “Ground”

connector on the EQS to the negative terminal of the

battery, a ground bus, or a verified ground location. The

factory head unit ground is not a good ground!

When the electrical connections are complete, you may

reconnect the negative terminal to your battery.

Figure 4: Side view of EQS

Remote Power Ground

Power Connector

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Audio Control EQS Spezifikationen Seite 10