Audio Control EQS Spezifikationen PDF herunterladen (Seite 9)

page 9

Ground Connection: Use the same gauge wire as you did for the

positive connector and run it from the “Ground” connector on the

6XS to the negative terminal of the battery, a ground bus, or a

verified ground location. The factory head unit ground is not a

good ground!

When the electrical connections are complete, you may reconnect

the negative terminal to your battery.

DASH CONTROL INSTALLATION

Placement and Mounting: The dash control may be mounted

under the dash using its own bracket or through a custom hole in the

dash. It should be mounted within reach of the driver and in a spot

where the LED is plainly visible. The dash control mounts with two

screws, which attach to the underside of the dashboard. Slide under

the dash and place the dash control in its mounting position. Mark

the mounting holes, drill pilot holes, and secure with two screws.

Custom Installation: For that custom look, the dash control can

be flush mounted in the dashboard or center console. Disassemble

the 6XS dash control from the mounting bracket. Start by pushing

the LED back out of its holder followed by removing the circuit

board and rotary control from the bracket. Drill a

⁄32” hole in the

dashboard for the control along with a

⁄8” hole for the lock tab and a

⁄64” hole for the LED holder. Reassemble the dash control compo-

nents on the dashboard and apply the new label over the openings.

Dual-Color LED: The LED on your dash control is

rain forest green and should brighten or dim when

you turn the knob either clockwise or

counter clockwise. Should you

wish to change the color

to amber, remove the

plug connected to the

LED and turn it 180

degrees and plus it

back in.

Figure 8: Dash mount remote

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Audio Control EQS Spezifikationen Seite 9